Info Inbox

Sounds good; someone is heading over right now to drop off the cover and the cabinet. They'll also pick up anything we haven't when they get there.

Thanks for everything! 

Best, 

Ivan 

On Wed, Apr 15, 2026 at 6:59 AM robby glass <robbyglass@harshco.com> wrote:

Sounds good, also we have some stuff for you guys that has not been picked up yet just FYI!

thanks,

Robby Glass General Manager robbyglass@harshco.com (928) 303-4586 harshcowaterjet.com @harshco_waterjet  @harshco_offroad 7442 E Butherus Drv, Scottsdale, AZ 85260 Please reference PO terms and conditions on www.harshcowaterjet.com If no tolerance is given standard tolerance for all parts is +-1/8"

Book time to meet with me

---

From: Ivan Arevalo <iarevalo@turnpack.com>
Sent: Tuesday, April 14, 2026 4:27 PM
To: robby glass <robbyglass@harshco.com>
Subject: Re: Bent Plate Remake

 

Alright that sounds good. Here's the link for the rivets: https://www.mcmaster.com/97447A215/ 

If you guys can do the cuts and bends for the cover, that would be great ! 

I'll get with Lorena about getting those both shipped to you. 

Best,

Ivan 

On Tue, Apr 14, 2026 at 6:13 AM robby glass <robbyglass@harshco.com> wrote:

Hey Ivan,

On the bent plate, you could blast the part you have and have the welds ground down flat, if you need a new one we can cut and bend it though- on the cabinet, we can put rivets in it, just send me the info on the rivets and the part, we can just stick them in it.

thanks,

Robby Glass General Manager robbyglass@harshco.com (928) 303-4586 harshcowaterjet.com @harshco_waterjet  @harshco_offroad 7442 E Butherus Drv, Scottsdale, AZ 85260 Please reference PO terms and conditions on www.harshcowaterjet.com If no tolerance is given standard tolerance for all parts is +-1/8"

Book time to meet with me

---

From: Ivan Arevalo <iarevalo@turnpack.com>
Sent: Monday, April 13, 2026 4:40 PM
To: robby glass <robbyglass@harshco.com>
Subject: Re: Bent Plate Remake

 

Forgot to add the photos for the Cabinet. Here you are.

On Mon, Apr 13, 2026 at 4:39 PM Ivan Arevalo <iarevalo@turnpack.com> wrote:

Hi Robby, 

My name's Ivan and I am with Turnpack. I wanted to contact you regarding a plate that requires rework or remaking, if necessary. 

The Hot Gas Machine Baseplate cover bent during shipping as pictured in the first two images below.

The welds on the interior of the same cover protrude too much, interfering with the baseplate's flush fit against the cover. 

We are curious about what it will take to get the cover redone so that the plate sits flat, no bends are present, and the welds are smaller. If the welds are an issue, we can find another company to complete them as requested, the bends alone would be sufficient for us.  

Additionally, the cabinet assembly was supposed to have these two pieces riveted together. Is there any way we can get that done and squared away as well?

Please let me know if you have any questions, need clarification, or require supporting information or documents. 

Thanks for your time, 

Ivan Arevalo