Info Inbox

Hi Ivan,

Here is the Simple Side Module Enclosure quote project number 26359M1 for Turnpack.

We aligned the frames and connectors for the simple side module. Please review 

Cost for Kit: $2,243.90 each

Cost for Assembled: $2,809.61 each

5-7 Days

Here is the base module top enclosure quote project number 26358M1 for Turnpack.

*****The bars you want cover caps on are not square on the end so will not go on.

*****If you want them squared, we can square them up and then add the end caps.

Cost for Kit: $1,012.17 each

Cost for Assembled: $1,272.10 each

5-7 Days

Best Regards,

Tony Haynes Technical Sales Representative FLODRAULIC Cell 480.997.2852 Fax 480.921.3272 1150 N. FIESTA BLVD. GILBERT, AZ 85233 ISO 9001:2015 Registered www.flodraulic.com

*** Important Notice: Send all Inquiries/Orders to our new Customer Service email address SWSales@flodraulicgroup.com***

---

From: Ivan Arevalo <iarevalo@turnpack.com>
Sent: Thursday, May 21, 2026 5:41 PM
To: Tony Haynes <thaynes@flodraulicgroup.com>
Cc: Brandon Benavidez <bbenavidez@turnpack.com>; Christopher Berger <cberger@turnpack.com>; Info at Turnpack <info@turnpack.com>
Subject: RFQ

Hi Tony, 

I've attached two .scene files for some extrusions that we would like pricing on below. 

The Base Module Top Enclosure should have the flat edge of the 40x80 3E facing outward. In MAYCAD, it shows up red as an error but we just want the slotted sides to be facing inward toward the enclosure. Additionally, I couldn't get the rubber caps onto the ends of the angled top extrusions in MAYCAD, but we want rubber caps on those. 

For the Simple Side Module Enclosure, do not quote the two "hurdles" that connect the back of the enclosure and the front 120x40 extrusion. Those are just placeholders to properly render the mating connection points. We also need additional mounting locations along the front extrusion for better support due to the extended length. 

Please reach out with any questions or concerns. 

Thank you for your assistance.

Best, 

Ivan